Close Shop Checklist
The shop is closed at 4:00 PM under normal conditions.
●At 3:45, have the workers present shut down the machines and start cleaning the shop.
●If you turn off the #25 breaker, the main exhaust system will shut down, but, you will still have power to the
110v outlets to run the vacuums.
●Sweep, dry mop, or vacuum the machines, tables, and, floor.
●Set the thermostats (2) to “winter” 66 degrees
●Turn the main power switch to the “off” position
●Check the paint storage cabinet and the wood storage locks, be sure they are locked.
●Put your plastic monitors nametag into the box in the drawer of the monitors desk
●Put on the “Woodshop Monitor” name tag back on the monitors desk
●Check exhaust vents in all locations, they should be closed. Exceptions: Table saws, jointer, & planer.
●Check all machine guards for proper positioning.
●Set the thermostats (2 units) winter day = 69; winter night = 66; summer = 75.
●Ceiling air filter units are on a timer, do not turn them off!!!
●Check all workers for: signing in on the log book, check to see that their dues are up to date,and proper eye safety protection is observed while working in the shop.
●Visitors – stay in the area of the monitors desk, they need eye protection if they venture into the shop where machines are being used.
●Requests by non- woodworker club members for performing woodworking operations – request to see their SCOV membership/activity card. Donations to the club can be placed in the donation box by the telephone.
●Observe club members while working in the shop, remind them to clean up their mess, on and around the machines before they leave for the day. Your NOT THEIR WIFE OR MOTHER!!!
●Lock the rear door, allen wrench for the safety bar latch is mounted on the right side of the door frame.
●Turn off the lights, exception is the fixture above the Monitors Desk.
●Lock the hallway door, put the key in the vault, change the combination, close the vault.
●At 3:45, have the workers present shut down the machines and start cleaning the shop.
●If you turn off the #25 breaker, the main exhaust system will shut down, but, you will still have power to the
110v outlets to run the vacuums.
●Sweep, dry mop, or vacuum the machines, tables, and, floor.
●Set the thermostats (2) to “winter” 66 degrees
●Turn the main power switch to the “off” position
●Check the paint storage cabinet and the wood storage locks, be sure they are locked.
●Put your plastic monitors nametag into the box in the drawer of the monitors desk
●Put on the “Woodshop Monitor” name tag back on the monitors desk
●Check exhaust vents in all locations, they should be closed. Exceptions: Table saws, jointer, & planer.
●Check all machine guards for proper positioning.
●Set the thermostats (2 units) winter day = 69; winter night = 66; summer = 75.
●Ceiling air filter units are on a timer, do not turn them off!!!
●Check all workers for: signing in on the log book, check to see that their dues are up to date,and proper eye safety protection is observed while working in the shop.
●Visitors – stay in the area of the monitors desk, they need eye protection if they venture into the shop where machines are being used.
●Requests by non- woodworker club members for performing woodworking operations – request to see their SCOV membership/activity card. Donations to the club can be placed in the donation box by the telephone.
●Observe club members while working in the shop, remind them to clean up their mess, on and around the machines before they leave for the day. Your NOT THEIR WIFE OR MOTHER!!!
●Lock the rear door, allen wrench for the safety bar latch is mounted on the right side of the door frame.
●Turn off the lights, exception is the fixture above the Monitors Desk.
●Lock the hallway door, put the key in the vault, change the combination, close the vault.